Cutting and drilling line Kaltenbach HDM 1431 / KDX 1215

Cutting line for Kaltenbach beams with 1450mm disc model HDM1431 and 3 Kaltenbach KDX 1215 drilling units. Videos of roller paths and transfers of Kaltenbach equipment disassembled and stored in our facilities. Cutting, drilling and marking line for beams DISC SAW - Disc saw with downward cutting. - Saw unit with gear, drive system and saw blade on wear-resistant rotating bearing wear. - Heavy saw gear with oil bath pinions, with inclined teeth, hardened and sharpened. - Hydraulic advance of the saw blade, adjustable according to the table, very fast recoil. - Hydraulic horizontal clamping device. Rear clamping jaw with long stroke clamping cylinder and automatic recoil limitation. - Vertical clamping block with self-adjusting push plate. - Oblique cutting device to adjust the angle from 45° left to 35° right. - Material sensor to automatically switch from rapid feed to work feed. - Hydraulically liftable feed roller for optimal transport of the material on the saw table. - Economical lubrication by means of a microdosing installation, especially suitable for sawing profiles. - Chip collector installed on the machine bench. Specifications: Cutting capacities: 90º cut Cut to degrees: IPBv Beam IPBs Beam IPE Beam DRILLING UNIT Work capabilities: - Vertical (Y axis) 1 unit. - Horizontal (Z and W axes) 2 units. Automatic tool change: 5 units. in each drilling unit. 3x5ud. = 15 in total MARKING UNIT FEEDING: 26 METERS OF ENTRY WITH BEAM FEEDER + 6 SIDE ARM FOR BEAM ENTRY IN PARALLEL TO THE PATHS OF ROLLERS 30 METERS OF ROLLER ROADS WITH EXIT + 6 SIDE ARMS 4 SIDE ARM FOR SMALL PIECES THE VAST MAJORITY OF ROLLERS ARE MOTORIZED It occupies approximately 60 linear meters between the input and output feeds. *Request machine installation plans.